The quality factor for this circuit was 15.71 which is definitely greater than the quality factor of the first order filter.ĭespite the slight increase in quality, Our team believes the single filter design will be sufficient for the purpose of this project. While this level of amplification is small compared to our desired frequency, it may make it harder to isolate the note we want. While the peak now has a gain of 40dB and the 3dB frequencies occurred at around 106 and 113Hz, the gain at the frequencies for the adjacent notes of E and D was now about 9dB. However, upon further examination, it seems that a second order circuit of this type may not be as beneficial as anticipated. The phase plot and magnitude plots are both shown below:Īs can be seen in the magnitude graph, the peak appears much steeper than the first graph, as expected. The bode plotter was then used to measure the new output. This involved essentially copying the first filter and feeding the output of the first into the input of the second. The quality factor for the circuit is therefore 11.Īfter performing this analysis, a similar analysis was run on a second order filter of the same design. The gain at both 82Hz and 147Hz was about 4dB while the gain at 110Hz was 20dB. Since the next two notes (E and D) occur at roughly 82Hz and 147Hz respectively, our circuit should theoretically be able to isolate our desired note to a good extent.

The 3dB points for the magnitude occurred at roughly 105Hz and 115Hz. The first plot is a phase plot while the second plot is the magnitude plot.Īs can be seen from the magnitude plot, the peak gain occurs just around 110Hz as desired for the note A. The measurement tool at the top of the design is a bode plotter which is built into multisim.Īfter running the bode plotter tool for this design the following plots were generated. The design is again shown below in the proper layout for testing. The circuit design laid out in the previous post was designed on multisim and bode plots were generated in order to determine the performance of the circuit and see if it would suit the needs of our project.

Bode plots in in Multisim